Cable Guide with plugs

NOTICE! 

This is an import from my older projects on Thingiverse. As such, there may be issues with the models and inconsistencies. My apologies, but I likely will not be revisiting these projects. If you make any necessary adjustments, please feel free to submit them as Remixes. Doing so would be greatly appreciated. Thanks again.

__________________________________________________________________________________________________________________
 

A revision of Woodcat64's Ender 3 V2 rear Cable Guide.

I replaced the screw holes with plugs so it should just slot right into the aluminium extrusion.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

Yes

Resolution:

200

Infill: 

10%

Filament: Generic PLA 
 

Notes:

May need cleaning up afterwards depending on your printer tolerances.

Category: 3D Printer Accessories