K1 + K1C HONEYCOMB TOOL WALL

*If you have any issues with printing or assembly, feel free to message me, and I'll do my best to assist you 😉.

/////ATTENTION

Make sure the bolts aren't too long. They shouldn't go past the frame's thickness to avoid damaging any internal components.

*There is a version [link] available that is compatible with the  HONEYCOMB STORAGE WALL [link] . 

*This version matches the dimensions of the back of the printer.

/////ATENTION

The pieces were designed with the printer's exact measurements. 

• Before starting printing the pieces, I recommend printing this tool https://www.printables.com/model/899470-xyz-accuracy-test-calibration-tool to test the dimensional accuracy of your printers and use this tool https://www.printables.com/model/480907-shrinkage-calculator-dimensional-calibration-tool to determine the correct scale based on the filament shrinkage you’ll be using.
• The pieces were developed with very tight tolerances (0.2mm) to ensure proper alignment and functionality of the assembly, so it’s important to make sure everything is well-calibrated or that you understand what is needed for everything to work correctly.

USE THE PDF FILE TO TEST THE DIMENSIONS

In the version shown in the photos, the pieces were made in ABS, and to achieve the correct dimensions, the pieces were scaled to 100.30% (POLYMAKER POLYLITE ABS). 

For the supports, I recommend using these settings (ORCASLICER):

• Top Z distance to [0.1mm] in the Support Tab
• Support Interface Fan Speed to [15%] under Cooling in the Filament settings.

/////DESCRIPTION

HONEYCOMB WALLS FOR CREALITY K1 + K1C ( +/- 277g of material)

The dimensions of the hexagons match those on the back of the printer. 

All previously designed accessories can be used with this wall.

The right side wall comes in two models: 

• 1st - Same as the left side. 
• 2nd - Includes support for the spool and sensor.

The central cover can be customized (STEP file included).

The pieces are attached to the printer with M3x8mm screws (see image).

All pieces are numbered on the longest side (see image).

Installation is done in numerical order for each piece. 

The first piece to be installed is the bottom left piece. 

Do not fully tighten the screws until all pieces are installed and pre-screwed. 

The screws removed from the printer can be used to secure the pieces together.

/////BOM to print LEFT SIDE: 

K1_K1C_HONEYCOMB_LEFT_WALL.zip

• 1 x LEFT_HONEYCOMB_1
• 1 x LEFT_HONEYCOMB_2
• 1 x LEFT_HONEYCOMB_3
• 1 x LEFT_HONEYCOMB_4
• 1 x COVER_1 (customizable)
• 2 x COVER_2

/////BOM to print RIGHT SIDE: 

K1_K1C_HONEYCOMB_RIGHT_WALL.zip

• 1 x RIGHT_HONEYCOMB_1
• 1 x RIGHT_HONEYCOMB_2
• 1 x RIGHT_HONEYCOMB_3
• 1 x RIGHT_HONEYCOMB_4
• 1 x COVER_1 (customizable)
• 2 x COVER_2

/////BOM to print RIGHT SIDE wiht SPOOL and SENSOR: K1_K1C_HONEYCOMB_RIGHT_WALL_SPOOL.zip

• 1 x RIGHT_HONEYCOMB_1_SPOOL
• 1 x RIGHT_HONEYCOMB_2_SPOOL
• 1 x RIGHT_HONEYCOMB_3_SPOOL
• 1 x RIGHT_HONEYCOMB_4_SPOOL
• 1 x HOLDER
• 1 x COVER_1 (customizable)
• 2 x COVER_2