BigBricks Wall Mount R2D2

When you start printing BigBricks figures you'll sooner or later get into trouble where to put them all, so I decided it was time for a proper wall mount.

It works with the R2D2 BigBricks figure and is interchangeable with my regular BigBricks and Leia Skirt wall mount (you can find that under my models) as it uses the same screw distance. 

You can switch R2D2's wall mount with the regular wall mount and vice versa in case you want to put your R2D2 to another spot without the need of drilling new holes.

For mounting use 2x 4,5mm Spax screws or similar (5mm hole / 10mm countersunk, 50mm screw distance).

Printed in Prusament PLA Galaxy Black

0,2mm IS Structural

3 perimeters

5 bottom / 5 top layers

15% Grid infill