Magnetic Knucklebones Game board

This is another simple magnetic Knucklebones board game that uses 6x3mm magnets (glue them in place with superglue or E6000 glue, be careful not to mix up the polarity!) to keep the board closed. It includes an optional loop to ensure the case is closed.

This version uses 10mm dice (I got mine from AliExpress).

The prints in the image were done on an Ender 3 S1 Pro from PLA+ (eSun) with a filament change:

• 0.4mm nozzle
• 0.2mm layer height
• 2-3 perimeters
• Low (10-15%) infill