2.5" disk holder for Standard Pi-4 Touch-Screen Case

An ugly-but-functional holder for 2.5" disks for use in One Nine Manufacturing Ltd's Standard Pi-4 Touch-Screen Case instead of the standard snap-on back cover.

Instructions: print two copies, mirroring one. Print with the side facing down and the angled tip facing away from the print bed. Minimal supports needed. Use the de-digitizer (aka. digit remover aka. darned sharp knife) supplied with your printer to remove non-smooth pieces, or use a filament that doesn't ooze.

The unit in the photo was printed with an oozing filament, colorFabb's allPHA, and minimal knife-usage was required.

The aim is to provide a functional product, not a pretty one. Tested to work with 0.6 nozzle, 0.15 layer height and allPHA natural.

FreeCAD design available on request.