Lerdge IX Extruder Motor Cover For DD

I updated my Lerdge IX to use the Aquarius Direct Drive.

Inserting the filament into the printer became a torment.

I used @raidy_980179's filament guide (https://www.printables.com/model/528005-lerdge-filament-sensor-improvement-for-direct-extr) to help guide the filament into the bowden tube.

However, I discovered that the motor shaft interferes with the installation.

There was a back cover here at Printables to replace the extruder motor, but I couldn't find it, I believe the creator must have removed it.

So I made one myself.

You will need 4x M3x6x5 Heat inserts.

I printed mine in ABS, however I believe PLA and PETG should work too.