Ground Anchor Driving Nut

This ground anchor driving nut makes it easier to drive anchors into the ground for swingsets or trampolines.

I was having difficulty installing ground anchors for my children's swingset. It was difficult to install by hand into the hard ground. I designed this to make it easier to install and remove ground anchors. It uses a 1" nut on one side so you will need a 1" socket. I found using a drill is better than a driver, as the driver can be hard on the printed piece. I start the anchor through the grass by hand and then use the nut to drive it in the rest of the way. I have used 20+ times now without it breaking.

It worked for these anchors, but I suspect it will work for others that look like this: https://a.co/d/ekIflfu

I recommend printing at 100% infill and I used 0.8mm nozzle to get a 0.32mm layer height. I printed in PLA+ and it is holding up so far.

Check out our website: www.mcmaker3d.com