MagSafe Card Wallet

A minimalist card wallet, easy to assemble and compatible with MagSafe.

It can hold up to four non-embossed credit cards or cards of a similar size, along with one printed “Card Protector Card” (see the “Print Files” section below).

It is compatible with iPhone 12, 13, 14, 15, 16 series, and other devices with MagSafe cases.

Caution: Magnetic stripe cards placed near the magnet ring on the backside may suffer magnetic damage, so please be cautious. Chip cards are unaffected.

Print Files

This card wallet is available in two versions, distinguished by the screw size used.
Please select the version you intend to use and print the corresponding files:

[ M3x6mm version ]

• [M3x6]_MagSafeCardWallet_front-panel.stl
• [M3x6]_MagSafeCardWallet_back-panel.stl

[ M2.5x6mm version ]

• [M2.5x6]_MagSafeCardWallet_front-panel.stl
• [M2.5x6]_MagSafeCardWallet_back-panel.stl

[ Optional (recommended for use) ]

• CardProtectorCard.stl
  (*Use as a sacrificial card to protect your cards from scratches or damage caused by rubbing against the spring plate.)

Print Settings

• Nozzle Size: 0.4mm
• Layer Height: 0.15mm (including first layer)
• Support: Required

Additional Purchase Required

• Magnet Ring for MagSafe: x1
  (*Get the “FOR INSIDE CASE” version available on AliExpress at the following link: https://www.aliexpress.com/item/1005006244960440.html)
   
• M3x6mm or M2.5x6mm SHCS: x4
  (*The back panel holes are designed to be self-tapping, so nuts are not required.)