Oral-B Holder for Schuko installation

ATTENTION: You need M3 threaded inserts with a length of 3mm and suitable M3 screws.

Special feature: Optimized for 0.4 mm nozzles, without supports (but bridging).

My recommendation for the print settings:

Material: PLA

Layer: 0.2mm

Nozzle: 0.4mm

Supports: No (but Bridging)

Alignment: Like Oral-B Logo / Page for melt-in thread inserts

Mounting instructions:

As shown in the photo, wind 2 coils under the plug.

Legal information:
This model is compatible with "Oral-B Basic Charger".
This is a free design variant based on my own measurement results. The model is not licensed by or associated with the original manufacturer. The manufacturer logo is for esoteric reasons and to identify the correct Toothbrush.
The sale of this model is prohibited. The model is intended for personal use and is intended to complement the manufacturer's product portfolio in this application.

I am not liable for incorrect use or other damages. I design to the best of my knowledge and belief with my printer settings.

Manufacturer:
If you are a brand owner, please contact me with any suggestions, proposals, criticism or other reasons.

For all other users:
Special requests, constructive criticism or other concerns? Then write to me.

Support:
I do not earn any money with these free models, but I do invest time, material and further training. If you want and can, you are welcome to support me. This can be done with donations in kind such as filament or money that I can use for tools or filament so that I can continue to provide models.
It is also possible to commission models after consultation.

Links:

Thread insert M3x3x4,2 =  https://de.aliexpress.com/item/1005004629314742.html