Prusa MK4 PSU Tool Holder

Hi,

I wanted to keep the area around my printer less cuttered and I wanted to use RostaP's Honeycomb storage wall for something. Further inspiration came from this design MK4 xBuddy HSW … but I wanted a storage solution for the side with the PSU.  The result is this design.

The holder which sits on top of the PSU and is clamped to the frame is in part (clamping geometry) based on a model from here, but in the meantime it is not available here anymore.

There is no glue or so necessary, the insert connector and the holder is “press fit”. 

printed with prusa MK4:
- in PETG
- 0,3 mm layer height
- 3 walls
- 15% cubic infill 
- supports enabled for the hex holes in the holder

If you want to use it you have to print:
- honey comb wall - 1 piece
- insert (spacer, thick pin) - 1 piece
- insert (connector, thin pin) - 2 pieces
- holder

Since this design is based on the original honey comb storage wall you can use any accessories for it you like.

Happy Printing!

Used the wall model and the empty insert of RostaP's design for my model.
I changed the size of the wall and used the empty insert as a design base to fit into my tool holder.