voron klicky klack door 7" touch display mount

Compatible with 2.4 or trident, with a klicky klack door mod installed.

please see the pictures for the measurements of the display i used, here's one on aliexpress:

https://www.aliexpress.com/item/1005002863549499.html

you'll need:

3x m3 x 25mm SHCS screws

1x m3 x 10mm SHCS screw

1x m3 heatset insert

3x 2020 m3 spring nut

some scraps of 3mm foam

1 x right angle hdmi cable. I use a CB1 and manta m8p so I need a micro HDMI cable, I used this one and it works perfect. a 2m cable is a bit too long, but works well for a 350mm build
https://t.ly/rxYEd

1 x right angle MICRO B to usb a cable (a 2m cable is a bit too long, but works well for a 350mm build) like this:

https://www.ebay.co.uk/itm/265155849378

A way to drill a 20mm hole into the perspex, I used a stepper drill bit which worked great

OPTIONAL:

20mm blanking grommet

2020 extrusion slot cover like this:
https://www.thingiverse.com/thing:5177513

INSTALLATION:

1:Put the heatset insert into the panel mount spacer. 

2:drill a 20mm hole in the acrylic panel, location isn't massiveley important, as long as it's behind the mount! I use nano nest panels (3 panels instead of one) and it still works great. place spring nuts into the extrusion

3:install HDMI cable, USB cable into display,put the display into the main mount, with the USB and hdmi slots facing away from the edge of the extrusion, use teh 10mm bolt to attach the panel spacer to the display mount. add 3mm foam to the flat surface of the panel dispaly mount spacer
4: route hdmi, USB cable through 20mm hole, I like to attach the cable together for this first section with small zip ties.
5: use the M3 25mm screws and the spacers to install the display mount onto the Door frame

6: route one cable to the outward facing 2020 extrusion slot of the voron and one to the right hand facing side (as pictured), leave slack for the door to be able to open and close without snagging the cables