fallout 4 type pip boy 3000

i will attempt to briefly explain scaling but for assembly please refer to the creator https://ytec3d.com/pip-boy-3000-mark-iv-assembly/

To make a pip-boy, you’ll first need to decide what version you want, and what size you will need. The version is either phone or accurate. Do you want to have a pip-boy that can hold your smartphone, pick the phone version. Do you want to do something a bit more challenging and make a wrist wearable computer with working buttons, pick the accurate version. With the accurate version you’ll probably need to make modifications to the design, but it does offer more accuracy and more possibilities.

The size is either determined by your wrist size or your phone size. The table below shows the sizes in millimeters. A is the rough diameter of the middle of your wrist. If your wrist is smaller than A at the middle, the Pip-Boy should fit.  F and G are the height and width of your phone (sideways). If your phone is smaller than these values, your phone will fit. Don’t worry too much about thickness, that should not be an issue.

base values (mm)  100%    108%    115%

A                               75.0     81.0      86.3

B                               71.0      76.7     81.7

C                              105.0   113.4   120.8

D                              170.0   183.6   195.5

Phone edition

F                              70.0     75.6    80.5

G                            141.0     152.3  162.2

PLEASE do tell me if i miss anything vital i still highly recommend using the creators website