Drive dimensions reference based on HP ODD PN: 659877-001, model DS-8A5LH. May fit to other ODD's from other manufacturers.
Parts needed:
12x M2 5mm bolts
10x M3 6mm bolts
18x M3 nuts (h=2.4mm)
Print:
2x odd_fc_button.stl
2x odd_fc_button_bracket.stl
2x odd_fc_hook_1.stl
2x odd_fc_hook_2.stl
2x odd_fc_hook_3.stl
2x odd_fc_hook_4.stl
2x odd_fc_led_diffuser.stl
2x odd_front_cover_short.stl or odd_front_cover_long.stl
1x odd_rear_bracket.stl
2x odd_side_bracket_new.stl
1x odd_side_bracket_add.stl (additional part, you may not need it)
1x dual_drive_front_panel.stl
1x dual_drive_side_panel_a.stl
1x dual_drive_side_panel_b_new.stl
2x dual_drive_top-bottom_panel.stl
Assembly:
For odd_fc_hook_1.stl use 3mm piece of 1.75mm filament, hook has hole for this. Button, button bracket and LED diffuser can be glued to ODD front cover, I used soldering iron for this.
ODD front cover: press hooks in to their sockets, use flat screwdriver, image 1.
Front & side panels: press M3 nuts in to their sockets, image 2, 3 & 4.
Put parts together according to assembly image 5 & 6.
Remarks:
Because every drive is little bit different, there may be alignment problems. odd_side_bracket_add.stl will help to fix this problem. Also there is small cylindrical part on dual_drive_top-bottom_panel.stl that may need to be removed or cut shorter, depending on your drive.
odd_front_cover_short.stl and odd_front_cover_long.stl width difference is 0.6mm.
Use 0.2mm or 0.1mm layer height. All parts are designed by 0.2mm step. 0.12/0.15/0.24mm etc layer height may produce problems when assembling.
When using other model ODD, than mentioned above, you may need to change hook(s) dimensions.
The author marked this model as their own original creation.