Cafelat Robot - Umikot Stand

It is important to note that I printed the Umikot as per the tips in the model linked below (i.e. for Cafelat Robot use Umikot's No Tab options, scale all Umikot parts to 94% on the X and Y axis, and leave Z axis scaling unchanged; the drilling of the needle holes using 1/16"/1.6mm drill bit was needed):

https://www.printables.com/model/820019-umikot-stand-for-cafelat-robot

For best fit, scale this model to 99% on the X and Y axis and leave Z axis scaling unchanged.

Made the stand fit the longer needles needed for a Cafelat Robot's Umikot; Optimized amount of filament needed; Bonus: Made the Robot's portafilter basket fit inside the stand and under the Umikot