Lid supporter for Creality K1/K1C Hinged Lid Raiser

If you are using the Creality K1/K1C Hinged Lid Riser and need to keep the lid open while printing some materials (e.g., PLA), do you feel that the opened lid is wobbling/ shaking a little too much during prints?

Look no further.

This add-on for the Creality K1/K1C Hinged Lid Riser allows the opened lid to rest on the printer's frame. As a result, the opened lid is a lot more stable during 3D printing. 

This add-on attaches to the rear hinged corners using a set of longer pins. No super-glue or screws needed.

It also works for JC-Creality K1 Hinged Lid Riser.

Change Log

• 21 Apr 2024 - Version 2. Updated design as the bowden tube squishing (slightly) at the right corner (where the filament sensor is). Added corners/ edges.
• 21 Apr 2024 - Version 1

You will need to print

• 2 x Lid Supporter
• 2 x holding pin

How I printed it

• Material: PLA
• Layer height: 0.20mm
• Perimeter: 5 walls
• Top and bottom: 3 walls
• Fill: 30%
• Fill pattern: Grid
• Support: None