Revision Snowhawk Shock Cord Adapters

Print vertically (as oriented).

Use 5 walls or however many it takes to fully remove all infill, you want these parts as solid as possible. 

Oriented as they are so the tension locks the part together, if printed horizontally you could suffer layer adhesion issues and you only get one pair of eyes.

Clicks in incredibly satisfyingly; requires wire cutters to remove (snip off piece on “inside” of goggles so the adapters come back out the front).

Uses 1/8" (3mm) elastic shock cord as the “strap”. Probably not going to be comfy if not wearing enclosed earpro as well, shock cord isn't exactly soft and supple like the stock straps.