Pin Vise for ER11 Collets

Pin Vise for ER11 Collets

If you have one of the popular 3018 Tabletop CNC mills, you probably have a set of ER11 collets for it.  A typical set has collets from 1.0 to 7.0 mm in 0.5 mm increments, plus a 3.125 collet specifically for 1/8" shank cutters.  They will typically clamp a shank a little larger or smaller than the nominal size, so most anything from a little under 1 mm to a little over 7 mm can be used.

This is a pin vise made to fit those collets.  It's on the large size for a pin vise, but that's called for since it can handle tool shanks of around 7 mm.  Most pin vises aren't intended for anything anywhere near that size.  It's still smaller than a drill chuck.

Printing:

Material: PLA

Nozzle: 0.3 mm

Shells: 0.8 mm

Infill: 16%