Prostop Encoder Clip

This is a replacement clip for the ones supplied with Prostop / Proscale Linear encoders from Accurate Technology Inc.

The originals have a lot of slop, and have poor holding. This replacement is quick to print, much more precise and accurate, and holds the encoder firmly. 

In my testing slop was reduced from approximately 0.2-0.3mm down to ~0.03mm using the new clip. With minor adjustments for a tighter fit that could possibly be reduced farther - but in my application it was unnecessary. I suspect the encoder itself is unable to reach any higher real-world accuracy.

Possible danger of damage to the encoder if you collide with something, this design is much less likely to self-release than the stock one. Be careful and check your track is clear before moving the encoder.

Originally printed using a Markforged Mark 2, and Onyx filament. 30% gyroid infill.