Semi-LowPoly Skull Bowl

This is a remix of the Zandeelio skull bowl on Thingiverse.

I found a few variations on the original skull bowl, but none of them fit the application I wanted it for. Starting with the model I got from Zandeelio, I trimmed 2mm off the bottom for better stability and printability. I widened both X and Y while keeping Z around the same, trying not to throw proportions too much. I then wanted a low-poly look, but not as extreme as possible, so I went with somewhere around 4-5k triangles to get the MID-poly look.

As it is now, I can keep 3-4 bananas, a couple apples and a few clementines. If you want to hold more fruit, I'd say increase the height of the model a bit more or maybe flare the brim of the skull more outwards.

Printed with Inland Gold Silk PLA.

Flattened bottom by 2mm for better balance and bed adhesion.

Widened X&Y significantly, kept Z the same.

Decreased triangle count to make it MID-poly.