Longer stem

Here are my recommended settings for priting:

Infill: Gyroid 10% to save filament

Perimeters: 3

Layer height: 0,2 mm

Nozzle: 0,4 or 0,6 mm

If your having bad adhesion:

• Brim is recommended or raft to make sure it doesnt fail!
• Use glue
• Make sure your bed is leveled

If you can set the infill on height 230-250mm to 100% to make thread last longer.

One part stem 23cm height + 2cm thread = 25cm z height so it should fit on most printers.