Yuari, baby magical dragon, articulated

Please read pdf for full instruction.

This dragon is very easy to print. In my opinion best size is 120%.
I printed with bambulab at a high quality setting and a 0.16 layer.
I use the brim for safety, but in the large version it may not be necessary.
Good calibration and retraction is necessary for a great result.

For personal use only
All my files are protected by Copyright, should NEVER be shared, resold or remixed.
To legally sell physical print of my design visit: www.bottega3d.com or subscribe a club commercial level

Settings:
NOZZLE: 0,4 mm.
LAYER: 0.16 – 0.20
OUTER WALLS: 3
INFILL: 10%
SUPPORTS: NO
Z-HOP: 0.8 
BRIM: If necessary