Prusa Enclosure sliding lid lock with Complete Modified Hinges

Does your Prusa Enclosure have the lid mod?  Do you like @MichaelQ 's Slider Lock Latch but you installed @PetrZikumd 's Complete modified Hinged lid for Original Prusa Enclosure mod?  This mod will work with all of the above!

You'll need x2 M3nS nuts and x2 M3 10mm screws

Material: PETG
Layer: 0.2mm
Perimeters: 5
Solid layers - top: 5
Solid layers - bottom: 5
Infill: 25% (Cubic)
Supports: Just paint supports in the square opening for the latch bar

It's not necessary but you can mirror the latch housing however the fit is a bit tight so when you assemble the housing it looks like it's one piece. 

marked places:

Post your makes if you like!

This remix will work with @PetrZikumd 's Complete modified Hinged lid for Original Prusa Enclosure mod.