5 inch Sander Holder - Wall Mount

I first printed Fantastic Plastic Person's version of a M18 Sander Wall Mount. However, the area where I was planning on mounting this was sheetrocked and I wasn't going to change that. I considered doing some slight modifications and remixing, but ultimately started clean and changed a few things. However, I wanted to make sure I gave inspirational credit to FPP. 

I focused on minimizing the plastic needed to print, while maximizing the stability and prioritizing vertical alignment for screws. I also made the ‘bed’ a large enough diameter that it should be forgiving of imperfectly attached sanding disks, and the lip low enough that it shouldn't have issues with the M18 sander's exhaust tube. 

Print Settings:
PLA
15% infill (3d honeycomb)
1 perimeter
2 layers top/bottom
No supports