Tea Light Candle Holder

A holder for up to 36 tea light candles. Accomodate candles of less than 40mm in diameter. 

• Model uses a 608 bearing (8x22x7mm) to allow it to spin. 
• Holes on the bottom of the base are 10.2mm in diameter and 1.5mm deep to accomodate rubber feet

Printed in Eryone Silk Blue/Green PLA and Jayo Black PLA+

Note: I included holes in the base for magnets so the holder would snap in place as you spin it, but this didn't work all that great with the clearances and weight of the candles. Something for version 2 or someone else to improve. Holes are 11mm in diameter and 2.2mm deep for 10x2mm magnets.