Inseego M3100 rugged case

I needed something to protect the screen, I often toss this in my back pack when on the go. 

If you're going to print the pins like me, instead of using screws, you're going to need to make one end of the pin smaller after printing, I usually use an exacto-knife to trim it down exactly so it doesn't break the smaller hinge hole but can still press fit. 

I didn't provide the model with the custom text on the surface because there are many different ways to achieve and it really all depends on what slicer/hardware is being used. There are tons of videos describing embossing online, if anyone has any troubles feel free to reach out

Sized down

Chopped and screwed