CREALITY K1 ACTIVATED CHARCOAL AIR FILTER

**UPDATE: Although very tight at first, the filter seems to loosen and can fall off over time due to the K1 back ribs flexing outward.  Recommend using doubleside tape or similar adhesive to keep filer plugged on the K1  (6/12/2024)

CREALITY K1 ACTIVATED CHARCOAL AIR FILTER

FEATURES

• Only 3 objects to print.
• No supports needed.
• Accepts 4mm Charcoal pellets OR Charcoal filter if you cut your own.
• Snap press together, no glue needed
• Cavity is roughly 57x60x19 if you want to cut to fit a charcoal filter pad.
• Snug fit thanks to tabs with friction bulges, adhesive tape recommended.
• Tight connection; air will flow though and not escape out the sides

INSTRUCTIONS FOR ACTIVATED CHARCOAL PELLETS

1. Snap on FILTER SCREEN on MAIN BODY (glue recommended shrinkage may occur over time)
2. Fill with 4mm activated charcoal pellets
3. Cover with COVER LID
4. After filling, shake to settle pellets to make room for more. Air will flow fine through a full chamber of pellets.

INSTRUCTIONS FOR ACTIVATED CHARCOAL FILTER PAD

1. Cut 60x60 square (you may add more than one square or fold over a 60x120)
2. Put filter pad into cavity of MAIN BODY (you can squish in the corners or round them off)
3. Snap FILTER SCREEN on MAIN BODY
4. Cover with COVER LID

Buy a Coffee for RaynovateLA