Star Trek: Prodigy Protostar Combadge

Simple model but needs some effort to be printed with the best quality. You can achieve this by either printing it upright with supports or flat with a very fine layer height. 

Updated April 17 2024 - The badge felt a little too small so increased the scale a bit and now it feels better. 

I printed flat at .05mm layer height, 100% infill, supports enabled for magnet holes, and drew the z-seams where it wouldn't interfere with the face of the badge. Takes about 2 hours to print with those settings, but the results were much better than expected. 

Uses 6x2mm magnets. I had to arrange the magnets a little oddly on the back in order to prevent them from affecting the perimeter wall thickness too much. 

Display stand included. 

Filaments used

I used CC3D antique gold PLA which gave it a nice golden luster.