Launching Pen Holder

A pen holder that launches its contents multiple feet into the air! 

Requires some hardware for assembly:

4x M3*6mm Bolts

1x M3*12mm Bolts

5x M3 Nut

1x 0.6*9.5*20mm spring

1x 0.8*9.5*50mm spring

The springs I got from a multi assortment on amazon, and same for the M3 hardware.

Printing Tips:

• Print the Piston head down, so that the spring notch is face up.
• Print the Tube vertically with the base down
• Print the Base vertically with the hex holes on the bottom
• Print the Latch on its side