Anker 737 Power Bank (Powercore 24K) TPU Case

TPU case to protect the Anker 737 power bank. Print standing upright, supports are included where needed.

Printed with 2 walls and 30% infill using a 0.4mm nozzle and NinjaTek NinjaFlex TPU with 85A hardness. 

As @KimBauters mentions, less stretchy 95A TPU might be a difficult fit when trying to slide on the case so I have a second model with a larger opening on the end. If you are in doubt you can print just the top part of the case using the slicer and check the fitment before printing the whole thing. The last picture shows the difference in the opening between the two models, the black one is printed using the 85A NinjaFlex and the grey one using Polymaker PolyFlex TPU-90A.

After printing, remove the support in the screen opening using a pair of cutters or a knife. Then wrestle the power bank into the case from the top.