Ocarina SC

I will publish new Ocarinas only on MakerWorld.

https://makerworld.com/en/@E.CAN3

If you like it, leave a like,  if you really like it and you want to support me, donations are welcome ;) PayPal

This ocarina has a completely redesigned soundhole and a unique windway design you may never seen before.

Choose a design(Clean,Scales,Hex), print it, remove brim, have fun :) 

Warning!

Soprano C Ocarinas are loud!

I print them with:

• 0.4 mm nozzle
• 0.8mm wall thickness
• 0.2 mm Layer hight
• 4 Top and Bottom layers
• Wall Ordering: Outside To Inside - Walls before Infill.
• 20% Infill - Gyroid
• 5mm Brim
• No Support

Print-Orientation:

Important

• Make sure your bed adhesion is good, else it will fail, so… clean your bed before printing!
• Avoid stringing
• Avoid Z-Seam on the labium (yellow edges):