perfect for my longboard (edited)
Longboard / Skateboard wall holder
Wall mounted holder for Skateboard / Longboard. Total width: 25 cm
Two versions for different wheel diameters.
155
772
9
4496
updated
November 2, 2019
Makes
Comments
I used the 70mm version for our longboards. We mounted it on the inside door of our outdoor closet door. When we open the door they swing a bit so I actually modified the mount to make some bottom mounts to stabilize them which worked!
Scaled down to 75% for my daughters skateboard (7.5inch width for wheels) and seems to have printed like a charm.
Printed using Esun PLA+ and I used the model with no screw holes so I could add my own. Works wonderfully! (edited)
Had to reduce the size to 96% because otherwise it won't fit for my Prusa MK3S+
Perfect fit for my son's board. Now we can keep it out of the way and not underfoot. Thanks! I printed it with three perimeters and at draft quality, since it's just going to be in the shed.
I like this. The model seemed too wide to fit my 3ks. I needed to reduce to 98%. Then after slicing I needed to go to 96%. I think that was because of the auto brim that is added and I was too lazy to figure out how to remove it. Also be careful about temp of your room, the edges pulled off the bed for me printing with petg, but I am printing in a basement. It makes no difference to the functionality of the print though.