Nespresso coffee pad dispenser

Print Settings

• Printer brand:

Ultimaker

• Printer:

Ultimaker 3 Extended

• Supports:

Yes

• Infill:

10%

Post-Printing

Does need some finishing, the pins go in the hole that are in the drawer, but only after the drawer is placed in the base, the two pins are there to keer the drawer from falling out the base when pulled to hard.
the link bit is used to connect the left stand to the last base.

How I Designed This

I used Sketchup to draw this up, about halfway through the project I was told not to use ketchup and I could better switch to Autodesk Fusion. I had e swished to Autodesk for my new designs, this one is finished in Sketchup.