Blobfish DLG v0.1 - VERY EARLY RELEASE

AUW: 45.5g 
Battery: 150mah 1s
Servo: 2x 1.7g rotary servo
Receiver: RX42 

Tailboom: 3mmx2mmx400mm carbon tube 

Wing spars: 6x 1mmx400mm carbon rod 

Instructions coming soon. It should be possible to reverse engineer from the photos if you're experienced. Nose cone should be printed vase mode with 0 top/bottom. Nose and wing panels are LW-PLA, Vase mode, 0 top, 2 bottom. Wing pieces are printed on the trailing edge on the bed. You'll have to trim out the sacrificial support areas with a sharp exacto blade. Cover with tissue paper of your choice, but be wary of warping as the trailing edge is quite thin.