In my garage I needed to have access for the EV charger cable from wallbox to the car. In order not putting this on the floor for a nice stumbling danger I hang it high under the ceiling (consisting of wooden beams (200x80mm HxW). The hangers are designed to rotate (only for adjustment). Holes in the channel can take Ø12mm (plastic) balls for a bit feeling like a ball bearing, which makes the cable slip better along the lined direction.
At the end of the traversed cable the EV charger cable comes down and is trapped in a type 2 plug receiver
https://www.printables.com/de/model/822412-holder-for-ev-charger-cable-type2
Holding the cable away from interference another holder was designed and attached on my IBC water container, so the cable is hung up in a slope. See photographs for better understanding.
Pretty easy solution, reversable installation if needed. Printed on my MK4 and Voron 2.4(350). Used PETG for the parts.
Enjoy electric driving!
Explore my other Printables: https://www.printables.com/de/@Tritschi
The author marked this model as their own original creation.