VR Warrior

For the last couple of months i am using VR for entertainment. 
Decided to create few filament paintings to decorate the “VR Corner”.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA PolyTerra Charcoal Black
• PLA+ Sunlu Gray
• PLA BambuLab Basic Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA BambuLab Basic Jade White

Swap Instructions:

• Start with Black
• At layer #4 (0.4mm) swap to Charcoal Black
• At layer #8 (0.72mm) swap to Sunlu Gray
• At layer #14 (1.2mm) swap to BambuLab Gray
• At layer #21 (1.76mm) swap to Light Gray
• At layer #27 (2.24mm) swap to Bone White
• At layer #31 (2.56mm) swap to Jade White for the rest.