Plant holder for Umage Butterflies hook

I wanted to add some plants to these small Umage hooks I got for my new kitchen. The plant holders are basic, but they fit the hooks and give enough space for small succulents. There's no complicated geometry so you can remix as you see fit (f.e. add drainage or wall mount).

Printed in PLA in 6 hours, with settings I use for planters:

• print temp. 220°C for first layer, 215°C for other layers (5°C more than usual for me)
• infill: 50%
• layer height .15
• no supports: you can print on one of the sides
• perimeters: 4

After the print I sand down the edges and sides just a bit.

Otherwise I used the Prusa generic PLA settings.

Do let me know if you see something I can improve, I'll gladly do so :).