LC Fiber Cap - Single with attached Holder

Thanks to Shaggyx86 | Printables.com for the original design.

Original design: LC Fiber Cap by Shaggyx86 | Download free STL model | Printables.com

This remix was designed with the intent of creating a fiber cap that cannot be lost.

Recommended print settings:

• PETG - for flexibility on the “leash” part
• 0.4mm nozzle size
• 0.2mm layer height
• 15% infill
• not the fastest speed; structural speed or less

Install recommendations:

• After print is complete, make sure the inside of the cap is clean and clear of debris. 
• Zip tie channel may be tight, can use a pair of needle nose pliers to pull it through.
• After snapping the cap on the first few times, it may require moving the clip of the fiber into the retaining portion a few times. Eventually it will seat correctly without any trouble.

Let me know how it works for you!

-------------------------------------

DISCLAIMER:

The 3D model file provided herein is offered as-is, without any warranties, express or implied, including but not limited to warranties of merchantability, fitness for a particular purpose, or non-infringement. The creator of this 3D model file shall not be held liable for any damages, including but not limited to direct, indirect, special, incidental, or consequential damages or losses arising from the use or misuse of this file.

Users of this 3D model file are solely responsible for determining its suitability for their intended purposes and for the manner in which it is utilized. The creator of this 3D model file does not guarantee the accuracy, completeness, or reliability of the file, and shall not be held responsible for any errors, omissions, or inaccuracies therein.

Furthermore, the creator of this 3D model file shall not be liable for any injuries, damages, or losses resulting from the use, modification, or distribution of this file, regardless of whether such use, modification, or distribution was suggested, advised, or encouraged by the creator.

By downloading, accessing, or using this 3D model file, users acknowledge and agree to hold harmless the creator from any claims, demands, or actions arising out of or in connection with the use of this file.

Split the model in half, added rails for fiber end alignment and thinned out cap thickness. Added a ~50mm “leash” to allow it to stay mounted to the end of the fiber.