Passt perfekt für 12l Honig Hoboks.
Fits perfect!
Ergonomic Bucket Handle
This part was designed to snap onto a standard 10l bucket.
55
290
6
1450
updated
November 1, 2019
Makes
Comments
This is a great design. Printed with Prusament PLA standing upright on one of the ends. I didn't need supports, brim or raft. (edited)
Great design. Exactly what I was looking for. I printed it on end with PETG and a raft just to make sure that it stuck to the build plate. Might not need the raft but it was cheap insurance. Again, a wonderful design, very hefty and comfortable. Worked perfectly for my old 5 gallon bucket. I will probably make more.
Much more comfortable than the stock handles that ended up breaking. This is a comfortable handle. Just be sure to add supports to the base plate. Originally I just dragged the file into PrusaSlicer and sliced, but then I would get these globs of filament being dragged by the hotend. As soon as I realized the end does not sit flat on the plate, I had PrusaSlicer add the supports and it printed just fine. It fits my 5gal Home Depot bucket perfectly.
Prusament PLA
.2mm speed
supports - support on build plate only
infill 20%
Thanks for the review! By the way, if you angle the handle 15° you can print it without any support. It depends on how well the filament sticks to your print bed.