Arrma Kraton/Outcast 4S - Extended Body Posts

I needed extended body posts so I could get a nitro truggy body to fit on my (electric) Kraton 4S V2. The new body I purchased had some interesting cut lines that made it difficult to get the body clips to go through in the rear (due to raises in the lexan that they would hit) and impossible to drill holes accurately for the front posts.

I duplicated the dimensions on the original body post and extended the height greatly. There are several holes for body clips, three to be exact. The body post platforms snap on nicely.

I recommend printing these out of TPU, this also means they can bend to where they are needed, if the body has an inconvenient shape like mine. If you don't need flexibility, PETG may be fine, but an upside-down landing will likely cause some trouble.

Printing Advice

Print them upright, with supports under the side arms, and a 4-5mm brim around the base.