Screwbox and measurement tool

Instructions:

Print out the Box, the Lock and decide between the Lid with or without the measurement tool. For the hinges I used steel wire push rods but you can also just use some filament.

Printing:

Box.stl:

• 0,2mm Layer Height (for faster printing)
• 3 Walls
• 15% infill
• support on
   

Lock.stl:

• 0,15mm Layer Height
• 3 Walls
• 15% Infill
• support off

Lid(with or without measurement tool):

• 0,2mm Layer Height (for faster printing)
• 3 Walls
• 15% infill
• support off
• (with measurement tool):
  •  You might want to print the upper 6 layers in a different color for better looks.
     

I used PLA for all prints.

Happy printing!!

Added it to a screw box.