10in-Rack-Unifi-Gateway-Max

This is a mount to put a Unifi Gateway Max router into a mini 10in network rack.

Print with the face of the mount down on the build sheet, rotated 45 degrees. Print with supports (I chose organic supports).

No hardware required, unit snaps in and doesn't move. This device doesn't have keyholes on the bottom for standoff screw mount to a flat surface. 

Printed in Prusament PLA .6mm nozzle, .3 layer height, 3 permiters. You could certainly use PETG or better, but this doesn't get anywhere near as hot as the USG or Cloudkey.