Slim Zyn Case

After printing, you will need to run a razor along the seams where the lid meets the case body and use a thin piece of plastic to pry the lid open to break the the lid from the body of the case. 

This model has 0.2 mm gaps between parts by default. If your printer struggles with small tolerances a model with 0.3 mm gaps is also available.

Recommended Print Parameters:

• Nozzle Diameter: 0.4 mm
• Layer Height: 0.2 mm
• Perimeters: 2
• Material: PLA, ABS/ASA, PC
• Print Orientation: Vertical