Creality K1 Adapted Moons Extruder

The goal of this design is to utilize my spare creality k1 extruder to my other 3d printer (specifically my CR-10 V2) and gain learning experience making 3D designs

Please refer to the original extruder design for the inner motion assembly

You will need two M3 x 6mm to bind this extruder to the hotend you have.

Print settings:

• Filament ABS
• 3 Walls
• 30% infill

Massive appreciation to the step files released by @Henlor and @Rolls17, my design would have been painful and demotivating without them.

This design removes the original M3 holes and instead provides new 2 holes to be sitting ontop of an existing hotend.

The 2 holes are 2.8mm in diameter so your M3 screws will make a thread

I have also removed a middle part of @Rolls17 design's to reduce the support needed