P1s Filament Guide for Side Spool holder

Small guide that you can use with spool holders. I use it with https://www.printables.com/model/610002-bambu-lab-p1s-side-spool-holder.

Two longer 16mm screws are needed to attach it. There's a bit of wiggle room so I tend to put it at a slight angle. Straight will work too.

The hole is 4mm big and I used a part of the tubing provided by Bambu to make the guide smooth inside. Just cut a piece that just fits. 

There's a second file that contains the connector for both tubes. That way you won't have to reach around the back ever.

IMPORTANT: The curvature of the hole inside is not as tight as the design makes it seem. So far it works just fine for me with PLA. Let me know if it works for you as well with other types of plastics. If not I might revise the print.