LEDBERG mount for 2020 (Ender 3)

Mount LEDBERG way above where the printhead of the Ender 3 gets ...

As I converted my Ender 3 Pro to Direct Drive with a simple 3D printed bracket mounting the motor sideways in such a way that you don't lose any build-volume, I also didn't want that motor to run into any LEDs at the top of the printer. The LEDBERG mounts that I could find were typically just placed at the same height as the top 2020 extrusion of the Ender 3 and would be hit by my Direct Drive conversion.

So, I created this simple bracket to mount all 3 LEDBERG bars (connected with custom-made power connectors - exactly what IKEA says you should not do of course). The bottom should tightly fit in the V-Slots of the 2020 bar. I printed 2 of these brackets to hold the LEDBERG bars at both ends, but you might get away with a single one or can add extra if you want things to look more robust.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

No

Supports:

No

0.28

Infill:

20%

Notes:

I did enable ironing to get both sides of the bracket fairly smooth. You could obviously also just sand it a bit.