Pooper Scooper (No Glue Required)

Taking out your pet for a walk, but tired of bending down to pick up after them?  Let this pooper scooper do the heavy lifting and dirty work of cleaning up after your pet.  

I printed most all of the pieces (except for the scoop_jaw_top and scoop_jaw_bottom) vertically up and down using a raft and with no supports.

The handle is connected to the jaw mechanism by using 1.75mm filament.  Tie it to the jaw mechanism and run it through the handle poles and hollow screws to the handle_end.  

At the handle_end, the handle_end_filament_screw is used to hold the filament in place after removing any extra slack.

The lever inside the handle_end can be a little tricky to detach.  I was able to do this by carefully inserting a thin piece of metal between the lever and the handle_end.  Use caution while doing this so that you don't get cut or break the lever.