Print-a-plant - printable Monstera plant

If you can't take care of a plant or don't want to pay for a fancy variant of Monstera, you're in the right place! Just print the planter and some leaves and your plant is ready.

Print at 0.2mm layer height. 

Types of leaves you can pick:

• Deliciosa
• Deliciosa variegata
• Adansoni (Monkey mask)
• Adansoni variegata
• Minima
• Minima variegata

There are 3 versions of the planter:

• Big - big planter that fits 25 leaves
• Medium - smaller version that also fits 25 leaves
• Small - tiny planter that fits 13 leaves

How to make it

Veins

If you want to make the veins a different color, change the filament for the second layer. 

Variegata version

To make the lighter parts in variegata version, change the color of the third layer. (Use lighter color, white or beige)

Shaping leaves

To shape the leaves and stem, use a lighter. Bending them cold can break them. They are thin enough to be bendable after a second of applying heat. The leaves can be bent to look more realistic.

Bend the leaf inwards through the middle, then bend the sides down. This should give it more natural shape.

Finishing the plant

After you shaped the leaf, cut the stem to the desired length and put it into a slot in the pot. There are a lot of slots for leaves in the pots, so make your plant as dense as you want.