Parametric Vase / Candle Holder / Pot

There is a vase mode version of the model and a full body version with whole columns.

If you download the Fusion 360 file, you can change the:

• inner_radius - inner radius
• column_radius - radius of one of the columns around the vase
• lower_height - height below the neck
• upper_height - height over the neck
• neck_inner_curve - defines the curvature towards the center
• neck_inner_limit - limits the neck_inner_curve to the neck_upper_curve value in order to maintain print stability, if you don't care use this parameter instead of the neck_inner_curve
• neck_upper_curve - defines the curvature up and down from the center of the neck (symmetrical)
• unit_mm - don't change this value, for calculations some parameters had to be unitless

If there are to many columns gabs will start to show, so the full body version doesn't work anymore, but the vase mode model still works fine.