Body shaver extension

Brothers, let's be honest. If you're single, removing hair from your back is at best challenging. Therefore, I created this body shaver extension to provide a remedy.
I designed it for my “Gillette Body” shaver. Other shavers might fit as well but I can't guarantee. Feel free to change or alter the clip if necessary. On the “Gillette Body”, it fits tightly to the “neck" of the shaver. 

Print instructions:

• For V1 + V2
  • 0.2mm layer height
  • 15% cubic infill. 
    • I'd recommend to rather go a littler higher, not lower. The clip fits rather tight around the shaver and less infill might cause it to break if used frequently.
• For V2 
  • I'd suggest to print the whole thing standing upright. This is because the clamp for the shaver is a really tight fit and horizontal printing might cause the clamp to break due to the weaknesses in layer adhesion. If you have a bed-slinger though, printing it upright might be difficult. I printed it laying on the bed and it words but I'd expect a better result if printed upright.

On the versions:

• V1 was just a very pragmatic approach. When using, the shaver does not really reach the skin well in the right angle. Therefore the results were not good at all. 
• V2 improves the downsides of V1 by introducing a 45° angle to the skin. This significantly improved the handling of the extension and the quality of the results.

So, lets get ready for summer, boys!