Cable Management - Spine (No Supports Required)

Manage your cables with that cable management spine.

Remix of Scott's Cable Spine.
I enhanced the way it could be printed to ensure no supports were needed.

• The link is now in 3 parts ( Link_1 * 1 and Link_2 * 2 ), this way you can print it with absolutely no supports, brims or rafts. (Saves a bit of filament).
   
• Once the push-fit bolt is in, the link is fully assemble and stays in place but still rotate as the spine should.
   
• The Base clamp is now around 90mm which suits your E7 FlexiSpot desk if you have one of those. (Just slide it up).
   

Don't forget to share your makes ! 

I'm looking forward to see your builds and setups

Thanks to Scott for the original make.

No Supports needed with those new model, enhanced Push fit clip with filet to make it surdier, modified base clamp to fit 90mm base desk.